MartinYale 62001 Spécifications télécharger pdf (Page 4)

The eccentric pulley assembly has the effect of separating the individual

envelopes so that only one envelope is fed at a time. You will note the pulley (N)

bounces up and down when the unit is in operation. This is normal.

3.8 Safety Interlock

The tab of the safety interlock (B) is released whenever the front cover assembly

(F) is lifted. Power is automatically cut which shuts off the machine so that the operator

never comes in contact with moving parts.

3.9 Automatic Resetting Thermal Motor Protection

In the unlikely event of a jam or other machine malfunction, the motor may auto-

matically shut down due to overheating. The thermal breaker will then self reset after the

motor cools to normal operating temperature. Caution: The machine may start run-

ning unexpectedly when an overheated motor cools to normal operating temper-

ature.

3.10 Self-sharpening Blades

The blades are precision ground of high carbon steel. As noted, they adjust for

width of cut and are self-sharpening. Note: Self-sharpening action is continuous

whenever mail is not going through the opener and will cause a whirring noise.

This is normal.

4.0 Installation and Set-up

4.1 Installation

Place the Model 62001 on a flat, level surface where it will be used. Make sure

ample space is provided for the catcher base. The cooling slots on the machine back

should be unobstructed. The socket-outlet shall be installed near the equipment and

shall be easily accessible.

4.2 Attach the plate deflector

This is a one-time only instal-

lation. Look for the plastic packet

inside the shipping carton. It con-

tains the nickel-plated plate deflector

and screw. Simply attach outside at

point as shown. (See Fig. 2)

4.3 Align the Catcher Base

The catcher base simply sits

on the exit side of the folder in a posi-

tion to catch processed envelopes as they are ejected from the machine (See Fig. 1 for

placement). The scrap bin lies in the narrow recess of the catcher base. The entire

assembly then is aligned so that the inside front wall of the scrap bin butts against the

front edge of the protruding lip of the scrap chute (See Fig. 2).

Figure 2

Control Knob

Front Deck

Scrap Chute

Plate

Deflector

1 2 3 4 5 6 7 8 9 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

MartinYale 62001 Spécifications Page 4

Commentaires sur ces manuels