MartinYale 62001 Spécifications télécharger pdf (Page 6)

6.2 Feed belts

Approximately once for every twenty hours of machine operation, clean the feed

belts of the unit with soap and water. Turn the machine off and on repeatedly to make

sure that the entire lengths of the belts are cleaned.

6.3 Holdback wheel maintenance

The holdback wheel does not rotate; hence it will wear a flat spot over time. If this

occurs, simply loosen the center screw of the holdback wheel and rotate it to expose a

fresh surface.

6.4 Blade Maintenance

For each 40,000 pieces of mail processed, coat both the upper and lower blades

with a blade emollient such as Premier Brand Trim Ease Lubricant (Martin Yale

#MRS037046, available through your Martin Yale Dealer).

7.0 Troubleshooting

Several of the most commonly encountered problems are listed below along with the

most common causes and remedies.

7.1 Envelopes Jam

7.2 Feeding

Problems

7.3 Envelopes

Only Partially

Cut

7.4 Envelope

Contents Cut

Scrap build-up in ski assem-

bly and blade assembly area

Scrap bin filled beyond

capacity

Feed belts dirty

Holdback wheel worn

Envelope too thick

Transport Wheel not rotating

Ski Assembly misadjusted

Cut adjusted to wide

Envelopes not tamped

Clean as outlined in section 6.1

Clear scrap out of letter opener and

make sure the scrap bin is cleared regu-

larly during machine use

Clean as described in section 6.2

Turn holdback wheel as described in

section 6.3

Make sure letter thickness is no more

than 1/4”

Verify that transport wheel spins as the

opener runs

Make sure ski assembly moves freely,

and the springs are still attached to both

ends of it.

Set the cut width adjustment to a nar-

rower setting

Prepare mail as outlined in section 5.2

Problem Possible Cause Remedy

1 2 3 4 5 6 7 8 9 10 11 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

MartinYale 62001 Spécifications Page 6

Commentaires sur ces manuels